High Pressure Mill is referred to as micro-grinding, also said the ultrafine grinding. High Pressure Mill is mainly used for the 500 hundred kinds of feldspar, talc, barite, marble, limestone, carbon black, clay and other materials in the ultra-fine powder processing, fine in the 500 mesh (25 microns) -2500 mesh (5 microns), most fine powder of 35 mesh (3.55 micron).

Repair and maintenance of high pressure mill bearing maintenance is very important, specifically the following four points:

First, the host center bearing refueling once every four times a blower bearing grease once a month.

Second, the room bearing a temperature not exceeding 70 degrees.

Third,Clean and replace the roller sets should be roller bearings and bearing room cleaning.

 

Fourth, the bearing during installation to ensure proper clearance.

High Pressure Mill scope of application in the production and the fineness of the same case, the system energy consumption is only one-third of the jet mill, jet mill in production and the fineness of the same case the price is only eighths ; high pressure mill of overlapping multi-pole sealed grinding device, good sealing performance, the effect of dust fully meet the national standards for dust emissions.