Several big taboo in the maintenance of using Grinding Mill
Shanghai Clirik Machinery Co.,Ltd ,which is specializing in research,manufacture and sales of all kinds of mining equipped, in order to providing better service for all new and old customers,We write this article to tell customers how to use and maintent Grinding Mill equipment.we hope this can helpful to our customers.
Usually grinding mill equipment out of spindle sliding bearing outside, the rest rotation of the rolling bearing, so this must be in good lubrication conditions.,or it will damage otherwise bearing and shorten service life. It is strictly prohibited to metal pieces into the machines, such as found out to stop the machine immediately, otherwise, it will damage the grinding and grinding ring. Second is charging should even, not less, and more. Charging too much can will into quartz duct, reduce production, easy to burn out motor, charging too little will also reduce production. Air volume adjustment is also very important, which is located in the intake pipe air volume control valves on the fan, in general, the largest open position, according to the fineness and production requirements appropriate adjustments. Located in the fan of discharging dust on the tube export regulator, transferred to feeding mouth place no dust jet can, air volume small, thin degree is high. But they should pay attention to, air volume small, the host of the precipitation in the wind beneath easily material, please adjust. According to the material size, soft hard, moisture content, different proportion, processing degree of different degrees, which can adjust the above parser, high speed, high fineness, speed is low, the fineness low. Improve the fineness, the output will be reduced, if it also can not reach the requirements should debug fan speed, the user can be flexible. When stop, first stop feeding, host still continue to move that residual material continue to ground, about a minute later, can close host motor and motor analyzer, stop grinding work, followed stop fan motor, so that blowing off of the remainder of the powder.